Flame 火焰感測器模組 火源探測 紅外接收火光檢測報警 4針

台灣智能感測科技官網, 購買更多關於 Flame, Flame-Detection, Infrared, lm393, 火光, 火災, 火焰, 紅外光, 的產品

產品編號： SNR-001811

Flame 火焰感測器模組 火源探測 紅外接收火光檢測報警 4針
Flame 火焰感測器模組

1、可以檢測火焰或者波長在760納米～1100納米範圍內的光源，打火機測試火焰距離為80cm，對火焰越大，測試距離越遠
2、探測角度60度左右，對火焰光譜特別靈敏
3 、靈敏度可調（圖中藍色數字電位器調節）
4、比較器輸出，信號乾淨，波形好，驅動能力強，超過15mA
5、配可調精密電位器調節靈敏度
6、工作電壓3.3V-5V
7、輸出形式：DO數字開關量輸出（0和1）和AO模擬電壓輸出
8、設有固定螺栓孔，方便安裝
9、小板PCB尺寸：3.2cm x 1.4cm
10、使用寬電壓LM393比較器
Flame 火焰感測器模組
模組使用說明：
1 、4針火焰感測器模組對火焰最敏感，對普通光也是有反應的，一般用做火焰報警等用途。
2、小板輸出接口可以與單片機IO口直接相連。
3、傳感器與火焰要保持一定距離，以免高溫損壞傳感器，對打火機測試火焰距離為80cm，對火焰越大，測試距離越遠。
4、小板模擬量輸出方式和AD轉換處理，可以獲得更高的精度。

Infrared Flame Detection Sensor Module for Arduino for Wide Voltage LM393 Comparator

Great for fire alarm, can detect the flame/wavelength at 760 nm to 1100 nm range of the light source.
Distance of the test flame lighter: 80cm. The larger the flame is, the larger the distance test is.
Detection angle is 60 degrees, flame spectrum is especially sensitive.
Adjustable sensitivity, it is shown in blue digital potentiometer adjustment.
Output signal waveform of the comparator is clean and good, driving ability: more than 15mA.
Working Voltage : 3-5.5V DC;Total Size : 5 x 1.5 x 1.5cm/2" x 0.59"x 0.59"(L*W*H)
lame Detection Sensor Module;Fit for : for Arduino
Accuracy adjustable
High Quality Atomic Market Product

Description:

- Great for fire alarm, can detect the flame/wavelength at 760 nm to 1100 nm range of the light source.
- Distance of the test flame lighter: 80cm. The larger the flame is, the larger the distance test is.
- Detection angle is 60 degrees, flame spectrum is especially sensitive.
- Adjustable sensitivity, it is shown in blue digital potentiometer adjustment.
- Output signal waveform of the comparator is clean and good, driving ability: more than 15mA.

Specification:

- Size: Approx. 32 ×14 ×3 mm/ 1.26 ×0.55 ×0.12 inch
- Operating Voltage: 3.3V-5V
- Output Form: DO digital switching outputs (0 and 1), and AO analog voltage output
- fixed bolt holes for easy installation
- Using a wide voltage LM393 comparator
- With adjustable precision potentiometer, sensitivity adjustment
- Can be directly connected with the microcontroller IO port

更多關於 Flame 火焰感測器模組 火源探測 紅外接收火光檢測報警 4針 的技術文件與範例